Work Station Case

Weatherproof Container

The Model MP-SSC , soft sided carry case, for the MP7 protects and stores the MP7 and accessories for easy organization and transportation. Much like a computer carry case, the MP-SSC is built specifically for the MP7.

The Model MP-RSC is a lockable shipping container for transportation of the MP7 and accessories for protection due to frequent shipping requirements of the portable instrument.

The Model MP-LPC is a lockable – site case for monitoring installations that require protection from the elements and tampering with the MP7 setup and controls. Internal layout is designed for the MP7 and PODs mounting. There is an access panel which allows the monitoring cables connection to the PODs interface connectors.

The Model MP-LVC is a dual banana plug to coax wire connection for use with the MP-30V, MP-300V or MP-20MA for connection to voltage input signals. Kit contains 4 separate cable/connector assemblies that are 48” in length. End connection is a Micrograbber connection for hook up to the test point or electrical point to monitor.

General Description:

The Model MP-HVC is a High Voltage Cable Assembly for use with the MP-600V and MP300V PODs for the MP7. Package consisting of the following items:

• 4MM Plug, 1000V Silicone Cable, Red 1
• 4MM Plug, 1000V Silicone Cable, Yellow 1
• 4MM Plug, 1000V Silicone Cable, Blue 1
• 4MM Plug, 1000V Silicone Cable, Gray 1
• 4MM Plug, 1000V Silicone Cable, White 4
• Alligator Clip, 4MM Plug-on, Red 4
• Alligator Clip, 4MM Plug-on, Black 4
• Cable Pouch 1

The MP-FRB is a replaceable battery pack for the Model MP7 located in the rear of the unit. The Battery is a: Sealed, rechargeable NiMH (Nickel Metal Hydride) cells consisting of 6 batteries at a voltage of 7.2 V dc with a capacity: 2.7 Ah.

Charging a depleted battery pack can be recharged in approximately six (6) hours, with a length of operation of more than two (2) hours when fully charged and with backlight on. When backlight is turned off, the unit can run continuously for more than three (3) hours.
Suggested replacement interval: Two years

The External Battery Charger for the MP7 bears the part number MP-EXB and is available as an optional accessory. Charging the battery pack(s) is especially useful when monitoring for short durations, where no standard 115 or 230 VAC power is available. Having multiple charged battery packs can provide power to the unit for several hours, allowing users to perform monitoring analysis in remote locations.

The Model MP-MEM is a certified Daytronic compact disc memory card for the MP-7 unit. Maximum formatted size of the memory card is 256Mbytes. Certified cards can be used as back up or spare memory cards which can store data up to the 10 KHz acquisition rate of the instrument and are recognizable by the MP7 unit.. Memory size, though the compact disc is greater than 2M byte, is restricted by the address capabilities within the MP7 device.